paper clip christmas cards

So I thought (we all thought) my paper clip Christmas crafts were done with.  But I realized I hadn’t crafted a single Christmas card for the blog this season.  Gasp!  Is Christmas ten days away?  

Given my recent posts, paper clips were right here within reach and this was just too easy.  I happen to have a huge tub of colored paper clips with perfect shades for Christmas shapes.

These cards can be easily crafted by little hands.  Just dab the paper clips on some glue and design away.

silver christmas tree from paper clips

Push pins.  Rubber bands.  And now for my final installment of Christmas décor out of office supplies.  A $4 box of 1,000 paper clips made up this avant-garde tree.

I was most looking forward to creating this out of all four trees I made, assuming all four would be equally simple.  I was wrong about this one.  The concept is simple, but, admittedly, fussy to achieve.

First you have to create a garland of paper clips by stringing them through a thin, light gauge wire.  I calculated about 2,000 consecutive seconds (33 minutes, at 2 seconds per paper clip) to finish this first and important step.  However, I was also intent on having each paper clip face the exact same way and discovered it was best to string the paper clip through the end that has a smaller loop.  The smaller loop acts as a lock to prevent the paper clip from shifting as much as it would had it been strung through the larger loop.   And I didn’t account for several spills.  Oh, also, 1,000 paper clips weren’t quite sufficient.  Luckily, I had some extras stashed from when I designed my paper clip necklace last December.   I used about 1,100 paper clips all in all, and the garland took much longer than the time allocated.

Then attaching the garland to a 6″ Styrofoam cone is presumably simple, too.  But not.  I inserted one end (at least 1-1/2″) of the wire into the side of the cone and started wrapping the garland around the cone (it really is important to use thin wire and not string, as the purpose of the wire is to be stuck into the cone).  This was when I ran into the problem of paper clips bunching together.  After several ineffective attempts, I managed to keep the paper clips aligned and flat on the table as I slowly wrapped the garland upwards.   I made sure I formed the wire along the cone to minimize the garland from sliding down (the weight of 1,100 paper clips will slide down).  Again, another important reason to use wire: so that the shape can be maintained.  When that is done, then the rest is simple.  I just secured the wire (at least 1-1/2″) into the top of the cone.

Despite it all, I’m glad I did this and the other trees!  If you’re just tuning in now, over the past three posts I made crystal Christmas trees from push pins, a shag Christmas tree from rubber bands, and rubber-band wrapped trees.  Enjoy!